1/14/2024 0 Comments Tube bending instructions chartRaise the clip and drop the tube into the space between the handle slide block and the bending form. Step 1: When placing the tube in the bender, raise the right handle of the bender as far as it will go so that it rests in a horizontal position as shown. Dies available for square tubing and nominal pipe sizes (NPS). Operating instructions for the lever-type tube bender. The Basic manual bender gives plenty of leverage to bend up to 2 inch round tube by hand, but can also be upgraded to hydraulics at any time, which would make it the same as our hydraulic benders. The NEW 90-degree rack means no more re-pinning the die on 90-degree bends and only 1 re-pin on a full 180 degree bend. The JMR basic bender includes nylon/graphite bushings at the pivot point, bronze bushings supporting the ratcheting mechanism, military-grade tough-coat finish, heat-treated 4140 steel pins, and five bending speeds. The JMR basic manual tube and pipe bender takes many of the same great features as the JMR Ultra manual tube and pipe bender and puts them in a very economical package for a DIY home fabricator or small shop environment. Bend 90 degrees without re-pinning the drive arm.Square Mild Steel Capacity (inches): 2 x.Nominal PIPE Capacity: 2 inch schedule 40.Round Aluminum Capacity (inches): 2.5 x.Round Chromoly Capacity (inches): 2 x.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |